fluence sysbacip

Posts

Re: Vikpro

Dear Sir Vikpro,  Can you plz send this calculation sheet to me at asif.sheikh54@yahoo.com and thanks for grindi...

Re: how to estimate the wear rate for Ball mill

Dear Sir Vikpro, Kindly if possible can u send it to me also at asif.sheikh54@yahoo.com Regards, Sheikh

Re: Material and Heat Balance for Clinkering

send me ur email address i will forward a file

Boulder

How can i detect the formation of boulder? Which parameters i have to look for the formation of boulder. Regards, ...

Re: How to Control Snoman at Cooler Static Grate

 Plz avoid the over burning of clinker and dusty condtion try to maintain your raw meal cheistry along with proper  ...

Kiln rotation

dear experts, is is advisable to run hot kiln on main drive with out feed for almost hours.What are possible damage...

Re: high ph outlet temp.

When you are increasing kiln feed also increasing the ID or kiln has already sufficient oxygen.Try to control ID fan...

Re: id fan motor bearing temp problem

what is the vibration status of ID fan both side.Check bearing alingment. Regards, Sheikh

Re: Run plant without cyclone dip tubes.

we are running a plant with double string top twin cyclones, cyclone 5 is with out dip tube and still we are gettin...

Re: white cement

Dear, If u are using coal then ash contents can damaged the whiteness of your clinker. regards, Sheikh