Raj Sahu

Posts

Re: True and apparent calcination degree

You may download the article from the as given path: www.cement.org/manufacture/Percent_ Calcination .pdf  · PDF f...

Re: Mono-Chamber Ball Mill

Hi Fjalali, Thanks for sharing the more information.If feed is  d80 (80% passing size) of 4000 micron  than calcul...

Re: high free lime

A decrease of one of the following parameters will decrease the free lime by approximately 1% at 1400 degree centigr...

Re: ID FAN AND KILN RPM

Kiln RPM should be varied to maintain constant volumetric filling % as per the prsent norms of 13-14% and Kiln ID fan...

Re: VRM and ball mill circulating load

Mainly in USA , the term circulating load is more often used than the circulation factor.Circulating load is percent...

Re: Mono-Chamber Ball Mill

Raw mill with classifyingll lining -one compartment mill conventional close circuit mill: 90mm=14%,80mm=19%,70mm=13...

Re: degree of kiln filling

Degree of kiln filling means volumetric filling percentage of kiln charge inside the kiln (i.e. charge volume divide...

Ignition temperature

Is there any equipment available for determination of ignition temperature of various fossil and alternative fuels?  

Later Strength

  Hi, What are the possible reasons for low strength gain from 7 to 28 days?

Grindability

Could you please inform me the supplier of Zeisel grindability test mill ?