bazarah

Posts

high free lime

  Hey Friends; How do you know the kiln feed is hard to burn? If free lime high in clinker   it ...

Re: how to estimate the wear rate for Ball mill

Dear Mr Kotiyal   Can u help to me to estimate the wear rate for impact and hummer crushers and also for...

Re: how to estimate the wear rate for Ball mill

Dear Mr Kotiyal   Can u help to me to estimate the wear rate for impact and hummer crushers and also for...

Re: Improve end cone phenomenon of the stockpile

    Ted Krapkat dear   Thank u for good information to improve the LSF for ...

Re: Improve end cone phenomenon of the stockpile

Dear friend, We have same problem, we wait your support Mr. HongMinh   Best regard.   Bazarah ...

Coating formation in Kiln Inlet

Sir, In our plant we are getting more coating problems at Kiln inlet and Riser duct. Please tell me what is reason f...

Re: snowman formation

Thanks 

snowman formation

Dear sir, In our plant we are facing frequent snowman formation problem (formation of heeped coatings near cooler i...