rajeshfls

Posts

re sulphure ring in kiln 14 to 22 meter

Hi, Is the ring issue a new problem or historical issue?? what is the Bottom stage meal SO3 during normal op...

Re: Kiln feed flow meter

Make sure you have enough venting for the flow meter. If you have positive pressure , then it can show false reading...

Re: High fuel consumption

It is due to kiln feed dilution from the preheater tower. When u use hot gas fro coal mill from downcomer, it carri...

Re: Cement roller press

We can crash stop the system and take samples from roller press discharge belt , then find out the density of the mat...

Re: firefiting system in coal mill

If the coal mill temp goes high, it can ignite the coal and result in explosion inside the mill and components. That...

Re: COAL FLUSHING PROBLEM

can u give more details on what system u have for coal feedign and fine coal storage and what make is that so that ...

Re: CIS MFR RFT & CFG MFR RFT

In CIS the plates are fixed. Not moving as in CFG. This will be good in mechanical point of view. Very less maintena...

Re: KIlN girth gear

In FLS the kiln type is called as ROTAX. They will have two tyres only. Kiln drive will rotate the supporting roller...

Re: kiln hood draft

From the cooler air input , part of the air is going to the cooler stack and remaining is used in kiln as secondary ...

Re: clinker factor

Also the feed factor depends on the tyoe of fuel being used. IF we use coal the ash will be absorbed with clinker a...