gks

Posts

re ROTARY AIR LOCK POWER CALCULATION

Dear ,        You may calculate on line by on line calculator given by    WWW.cementgrindingofficer.com /Rot...

Sepol

Dear expert,         How to balance sp. power consumption of sepol fan in term of kwh / mt cement in OPC  vs PP...

re Increase in production due to close circuiting?

Dear,      Without full circuit with present  mill design. we can say how much tph will increased.But  say that...

re Raw Coal, Pulverized Coal and Preheater exhaust temperature

Dear sir,       As you have change coal quality , let suppose  % Ash increase than Ph exith temp of gas increas...

Kiln nose ring air flow design

Dear expert ,   How to design nose ring fan  for kiln outlet tip casting cooling.. Some say air  volume requ...

re CIS MFR Under grate Pressure

Dear,    keep air density constant till cooler operation not stable with minimum flow in MFR ant put on auto fi...

Hood draft

Dear      What is effect of hood draft on kiln pickup at time of kiln not pickup without change  heat input to ...

re Running Raw Mill without kiln gases.

Dear,   Run raw without kiln hot gas is based upon your kiln stoppage time . But normaly kiln with raw mill sho...

re high blaine - high residue

Dear   Any change in clinker or additive  used  for above grinding  mill. What factor  you have selected for...

re Kiln flame effect

 We have fives pillard low nox burner . Water spray with centre. pipe  reduced over all  flame temp. but  NOx i...