What is lime used for in cement ? Many people tell me different answers. What is the ratio of lime to cement and when to use in a particular job ?

The simple answer is "around one per cent", but the exact response may rather depend what you mean by "lime" and what class of cement you are talking about! Portland cement is ground from a clinker produced by heat treatment of a raw mix that consists mainly of finely-ground limestone and shale. On heating, the limestone forms lime which, in due course, conbines with other substances to form calcium silicates and aluminates and there is only one per cent or so residual uncombined lime remaining. Cement sets and gains strength through the reaction of these substances with water. So, some people would say that a lot of lime goes into cement: if you analyse the clinker and do not take account of the fact that the lime is combined as aluminates and silicates, then about 65 per cent of ordinary Portland cement is "lime". Now when it comes to making mortar, we have a different story. A long time ago, lime/sand mortars were used (about 25% lime in the mix); then, to get more rapid strength development and higher final strength, people started to add cement. (Just using cement and sand leaves you with a lot af sand and not much cement and a harsh mix that is difficult to work with a trowel - and if you add more cement to overcome this then the mortar becomes too strong for general use.) So, some traditional mortar mixes are 2 parts of cement plus 1 of lime and 9 of sand ( or 2 - 2 - 12, or 2 - 6- 24 are also OK). You can buy masonry cements instead: in North America these are typically made from about 50% Portland cement interground with an inert material such as limestone and a plasticiser to aid workability and you can mix 1 part with 3 parts of sand to get a mortar roughly equivalent to one of the traditional mixes. Now, if someone says "lime" instead of "limestone" - as is common in some regions of the world - you need to change our first answer quite a bit! Concrete mix design is quite another field. Concrete is basically a mixture of aggregate - crushed stones or gravel - in which the voids have been filled by a mortar mix (sand and cement) that yields suitable flow properties when fresh and, in due course, appropriate strength. (Add too much water to get it to flow OK and you lose out on ultimate strength; add too little water and the mix will not flow into all the corners where it is needed!) Most builders' merchants, do-it-yourself outlets and suppliers of cement will give you rules of thumb as to what mixes to use for different jobs.

What should be the standard sieve sizes for limestone feeding to Vertical roller mill. We were earlier using Limestone having bond index of 8-9kWh/short tonne. Now we are having limestone with bond index 11-14kWh/ short tonne. Wether any reduction in mill feed size will improve the output of the rawmill. How to calculate finess modulus of crushed limestone and what is the optimum value for VRM.

Yes, reducing the size of the feed to the raw mill should result in an increase in output. Bond's equations use the size grading where 80 per cent of the feed is passing to characterise the size of the feed to the mill. The optimum size of mill feed is related to the nip angle between the rollers and table. 60mm is quoted as the maximum size.