Amir Feroze
7 posts
TimePosted 12/10/2006 06:24:49

Atox Raw Mill Rollers Seal Damaging?

We are facing frequent problem of Atox raw mill Rollers seal damaging, what are the possible reasons.

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

SIMEQ
4 posts
TimePosted 21/10/2006 12:49:20
SIMEQ says

Re: Atox Raw Mill Rollers Seal Damaging?

Assuming your lubrication system is working as it should, you could consider the temperature used while heating up the mill. I think the maximum allowed heating temperature is stated in the mill manual.

Reply

Madsniggy
4 posts
TimePosted 28/11/2006 05:49:00
Madsniggy says

Re: Atox Raw Mill Rollers Seal Damaging?

Hai,

Feroze,

We too have two ATOX-50 RAW MILLS.

We are also facing the problem. But as far as our

experience says this can be due to if lubricaation is not sufficent,

and if the sealing pressure not as per the requirement the roller

seals can get damaged. Even though if mill inlet

temperature is high and if proper lubrication is maintained this

problem could be avoided.

MadSniggy

Reply

shiggavi
11 posts
TimePosted 04/05/2007 09:59:45
shiggavi says

Re: Atox Raw Mill Rollers Seal Damaging?

Dear Amir,

I tihnk you are putting in lot of oil inside the roller which is creating pressure resulting into seal damage. what i feel is you can adjust the start/stop of the feeding pump to the roller in roller lub unit.

 

 

 

Reply