mb14
9 posts
TimePosted 11/09/2009 21:58:45
mb14 says

Cement ball mills without water injection

Dear all,

Did anyone has experience or read about operating cement ball mills without water injection?

If you have any information please pass it to me.

Thanks

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

Vikpro
77 posts
TimePosted 12/09/2009 04:46:55
Vikpro says

Re: Cement ball mills without water injection

Dear mb14,

As per my experience it is not possible. I have calculated by considering cement mill somewhere in -40 C climatic condition than also i can reduce only 25 % of present water consumption.

Vikpro

 

Reply

mb14
9 posts
TimePosted 12/09/2009 23:25:55
mb14 says

Re: Cement ball mills without water injection

Dear Vikpro ,

Thank you for your reply ,what about the case of installation of O-Sepa separator which utilizes fresh air for cooling the cement product .

Regards

 

Reply

lalbatros
138 posts
TimePosted 14/09/2009 19:57:16
lalbatros says

Re: Cement ball mills without water injection

mb14,
Vikpro,

You need to perform a full heat and mass balance calculation to decide about that.
It is obvious that the amount of fresh air should play a role as well as the specific power consumption and the temperatures of your raw materials and several other parameters.
If your clinker is hot, you might consider some cooling before the mill.
The rate of air recirculation on the separator is an important parameter as it is related to the amount of fresh air.
It also depends on if you have wet material entering your mill.

Lal

Reply