Dear All,
Can any body explain regarding Kiln Floating ( up & down ). What is the use of floating for the kiln and for what length/Dia/Capacity for the Kiln.
with regards
Komar
BK
Pl.help me to get clarify for above
ILA
Hello Bandari
When kiln rotates such that downhill thrust roller is only engaged for a partial revolution and all rollers are correctly skewed than we can say the kiln is floating . the thrust tire will always have a slide ammount of wobble , While a thrust roller is in contact that causes the kiln to be pushed uphill for part of rotation , As the wobble then moves away from contact with thrust roller , the kiln is move gently downhill for that part of rotation , the cycle then repeats .
I hope you could find what was you looking for
Regards
Mech. & Process. Expert
ILA
Kumar
Dear Bhandari,
Because of the kiln slope, the kiln during running has the tendency to slide towards kiln hood at the discharge end due to gravitational force.so to avoid this and to keep it at its position, thruster is used,which pushes it upwards after a set downward position is reached as indicated by the sensor.And when a set upward position is reached the thruster releases its push and then kiln again starts slowly sliding downwards,so this cycle continues.It is required for all modern kilns of different capacities.