239 posts
TimePosted
29/10/2010 11:02:03
xxxx
says
CONVERSION FROM FAD
HOW CAN I CONVERT MY F K PUMP COMPRESSOR 58 M3/MIN FAD TO THE ACTUAL VOLUME CONSUMPTION IN MY PUMP. MY LINE PRESSURE IS 1.3 KG PER CM2. WHAT MEASUREMENTS SHOULD I CARRY OUT TO FIND OUT THE AIR CONSUMPTION IN F K PUMP . ACTUALLY I WANT TO FIND OUT THE HEAT INPUT IN KILN BY THIS AIR GOING INTO PREHEATER WITH FEED. RAJ
Know the answer to this question? Join the community and register for a free guest account to post a reply.
324 posts
TimePosted
29/10/2010 18:01:49
Michael Clark
says
Re: CONVERSION FROM FAD
If the air is at ambient temperature and you make your reference temperature ambient then there is no heat input to the kiln or cooler with the air through the cooler fans, any inleaking air, etc.
239 posts
TimePosted
30/10/2010 03:22:27
xxxx
says
Re: CONVERSION FROM FAD
My basic question is how to calculate actual m3 from FAD if the line pressure is 1.3 ksc & compressed air temp. is always higher than the ambient or the FAD. My FAD is 58 m3/min .xxxx:
HOW CAN I CONVERT MY F K PUMP COMPRESSOR 58 M3/MIN FAD TO THE ACTUAL VOLUME CONSUMPTION IN MY PUMP. MY LINE PRESSURE IS 1.3 KG PER CM2. WHAT MEASUREMENTS SHOULD I CARRY OUT TO FIND OUT THE AIR CONSUMPTION IN F K PUMP . ACTUALLY I WANT TO FIND OUT THE HEAT INPUT IN KILN BY THIS AIR GOING INTO PREHEATER WITH FEED. RAJ
Page
1
of
1
1