Dear all!
We have a problem with coating in the kiln as below:
the coating in the kiln is not stable, so whenever the kiln condition changes as coal quality change, rawmeal changes... then coating fall down so kilnshell temperature high (around outlet tyre) and affect to the IKN cooler. I thought it's because of kiln burner not good, but not sure. Anyone has experience to solve it.
Thank alot!
Dear Mr Vuha,
I think you should try to stabilize your Sec and Ter air T as much as possible. Also coal conveying air should be checked for any fluctuation. I have experienced problems like this due to fluctuation of coal conveying air. And we installed high capacity coal conveying blowers to overcome this fluctuation. More over try to run kiln little bit hot to overcome lab/ process fluctuations. You can also reduce slight kiln rpm if any allowance in your system. But in long term, you must get rid of the chemistry and process fluctuations as you mentioned. Also mention what type of burner you are using for any further discussion.
Have a nice day.
EngrS
if there is a flactuations in silica ratio and alumina ratio so its normal to have a fallen down coat.
so you should first stabilize the silica and alumina ratio.