We are facing the problem of kiln inlet hot material leakage.So far we could not traceout the reason for such heavy spillage and feed reduction was the only alternative step so far we have chosen.Anybody having any experience will be appreciated.
Mohan.M
dear friend see any abnormal coating in ur and clinker ball in kiln.. avoid such conditions due to this kiln filling degree disturbed and material leakage statrted at kiln inlet.
Did the kiln inlet spillage happen after a shutdown(after brick refractory changing) or suddenly one fine day
Yeah I would say..Its on one fine day....For some reasons(unknown) there takes place heavy leakage and for that we are forced to reduce the feed rate drastically (from 500t/h to some times 400t/h or less) and run the kiln....The spillage then stops after sometimes and we gradually increase the feed rate and come back to the original level.