Dear Sahu G

I have already written the mill dimensions like

4.4*11m

28% filling

180t gr. media

15.48 rpm

mill installed kw 2600

monochamber mill

gr. media 30mm to 15mm

BM after RP in combi ckt

This the available information with me.

thanks

DHARMENDRA

I think you are putting three input data given below wrongly for calculating the mill net power [kW net]:

1. Mill effective diameter (The mill internal diameter measured from liner top surface)

2.Calculation of mill central distance ( h) from mill centre to media top layer

 For calculation of arm of gravity central distance is required.

 3.Grinding media tonnage data and volumetric filling % is wrongly estimated

The formula is well proven and it will give accurate result only when you put correct measured input data.

DEAR SIR

ACTUALLY MILL HAS NOT STARTED SO FAR .

IT HAS BEEN SUPPLIED BY KRUPP WITH THE DIMENSIONS GIVEN ABOVE. MY DOUBT IS THAT THE INSTALLED POWER IS ONLY 2600 KW WHILE THE CALCULATED POWER WITH THE GIVEN DATA IS ALREADY 2600KW OR MORE .

I AM JUST CONFIRMING THE DATAS GIVEN BY SUPPLIER.

PLEASE DO COMMENT.

THANKS

DHARMENDRA

Hi Dharmendra,

Pease ask the OEM, an effective mill internal diameter of the mill he has considered to design the mill main drie power and the calculate the mill main drive power @ 28% vilumetric filling level.You wlll get the answer of your queries.