vivek
2 posts
TimePosted 16/12/2013 17:32:14
vivek says

raw mill esp dust emission very high

Dear sir, i am taking hot gas for vrm from preheater outlet , preheater duct is also conected in (gct) gas condictioning tower and their is also spreing water. if vrm is running it is ok emission. but if vrm is not running any reason then emission is very high. please tell me sir, thank u sir.

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

Andrew
2 posts
TimePosted 07/01/2014 12:52:22
Andrew says

re raw mill esp dust emission very high

Are your gas velocitys the same Mill on /off  all air to ESP must be as slow as possible across air distrubution panel to allow precollection to work and collector plates to capture dust ,kiln dust carry over may have low conductivity ,try total evaporation water air spray in ducting prior to ESP  to increase conductivity of dust ,can you increase temprature when mill off

Reply

Harald
11 posts
TimePosted 14/01/2014 09:59:17
Harald says

re raw mill esp dust emission very high

Dear Vivek

Maybe it is a problem with the preheater top stage cyclones.

If you are interested we can help you.

Harald

Reply