Dear Expert,
We always maintain ball mill outlet fineness >60% baline respect to the final product (at mill discharge material).
Can you please share any related document for this rule.
or any guideline what should be our fineness at ball mill (cement) out let fineness (blaine or %R45) in close circuit mill (with or with out pregrinder).
regards
rajuverma
dear expert
any sharing please give your coments on that
regards
raju verma
Hi,
Its the same as circulation factor and it depends on your product blaine and seperator type.
See below:
Regards;
FJalali
Dear Mr. jalali
can you please give some more elaboration for your point, basically I am asking about at mill discharge finess ( in which separator work excluded)
thanks
regards
raju