Avatar

Bhaskar Agate

Registered User Pune (Maharashtra) INDIA Trainer-Guest/visiting faculty

Re: Ball Mill Load & feed

Dear xxxx, When the mill is chocked it only rotates like a drum.The feed material + balls thrown cetrifugally outw...

Re: Flux

As I understand,the optimum requirement of Alumina,Iron,lime and Silica in Type1 clinker is predominantly fullfilled...

Re: BY PASS RAW MATERIALS

Please refer cement standards specificatinons or standard books where parmissible alkali and chlorides are mentioned...

Re: API SPEC 10A for oil well cement

1. API Spec 10A 01-Apr-2002 This Product Has Been Amended Specification for Cements and Materials for...

Re: clinker ball formation in pre burning zone of the rotary kiln

Put air blasters at appropriate locations with sequential timers and use them regularly. Bhaskar Agate

Re: BY PASS RAW MATERIALS

Your analysis figures indicate clinker material.Hence,it may be used as an additive(small dosage) with Portland ceme...

Re: Replacing coal by natural gas in kilns

You may please refer Fuel Chapter of Walter Duda book vol.1 on Cement Technology as an additional proof.The naration...

Re: Percentage loss in raw materials,clinker,cement and Coal stocks inventory

Dear Engr.Amin, I endorse your views. All raw materials are practically received with some moisture and consumed o...

Re: Percentage loss in raw materials,clinker,cement and Coal stocks inventory

Dear Sunlight, You must be familiar with Heat and Mass balance exercise.Is it not! It will be therefore interesting...

Re: Percentage loss in raw materials,clinker,cement and Coal stocks inventory

This is a tricky question.For efficient operation of the plant the losses in all raw materials should be as low as p...

;