Nael
Registered User
Qatar
Production Engineer
Hey Ted; I have read your answer to Emad about dusty clinker and would ask you if there is any relation between AR...
Hi Ted; Thank you for your answer. I am agree with you 100%, Sulfur/ Alkali Ratio is very high in kiln-1. We have r...
Hey; We have 3 preheater kilns with PC and bypass system, kiln feed approximately the same for all the kilns, gas ...
hey; Check also the flowmeter of kiln feed. If there is any false air; flowmeter will give you less feed with high...
Hey; We have run our kiln (with high speed) three months without thrust roller due to failure in thrust pump, but ...
Hey; Low efficiency of cooler first grate fans, very high temperatures of secondary air/ variation of secondary a...
Hey; We are running 5000 tpd kiln with the maximum capacity without bottom cyclone dip tube (due to shortage of sp...
Hey; Check this question .. it is good answer for your question http://www.cemnet.com/cs/forums/thread/2786.aspx ...
Hey; Our kiln capacity is 5000 tpd with 5 stages preheater and bypass system, last week the dip tube of cyclone 5 (...
* Stopping the kiln is not an easy decision and most of you know what is the cost of kiln stoppage. Here in this for...
;