Bhaskar Agate

Posts

Re: High wear rate at mill inlet than the mill outlet shell liner plate in 1st chaber of cement mill explain????

1st chamber does the job of crushing where cascading and cateracting actions are taking place to break the bigger si...

Re: High Liter weight

Pl.let us know which clinker size fraction is used for determination of litre weight and why this fraction is select...

Re: sand stone...

Raw meal is a Chemical composition of major oxides Silica(SiO2),Alumina(Al2O3), Irion(Fe2O3),Lime(CaO) and other min...

Re: clinker litrweight

Ted has explained very nicely on your query.Could you tell us which clinker size is used for litre weight determinat...

Re: cement temperature suitable for airslides

Besides the temp.blowers should supply dry air to air slides.Blowers without proper dryers observed in many plants.Hu...

Re: Suitable temperature for cement storage in silo and also for better roto packer performance

If the silos are not cleaned periodically,the extraction of cement problem is inevitable. Normally,vibrating scree...

Re: ball mill

Pl.refer standard book on cement by W.Duda.You will get the answers to your questions.

Re: combustion air

You need ultimate analysis of coal and refer standard book on Cement heat balance calculations for the same.

Re: free lime

High free lime means uncombined lime which is left out after the formation  of clinker compounds C4AF,C3A,C2S and C3S...

Re: how to estimate the wear rate for Ball mill

As per the experience, for 3 chambers 1000 HP cement mill, the given below thumb rule of wear rate and Kwh was found...