ovancantfort

Posts

re Effect of Immersion / dip tube in lower stage of PH cyclone

1)Hope dust losses remained same because first 3 stages having immersion tubes and no changes in it. Correct. ...

Re: LSF

It is a simple mass balance. Inputs = outputs Input: kiln feed Outputs clinker and prehgeater dust If preheater d...

Re: measurement of clinker temterature

A pyrometer will not report proper clinker temperature because it is overly sensitive to pieces of clinker with high...

Re: Pet Coke

On all three questions, the answer should be "it depends on your kiln" 1. Overburning can be avoided by good traini...

Re: Raw Meal fineness x kiln output

In addition, if the meal is really fine, the separation efficiency of the preheater cyclones will be less. Dust goin...

Re: Clinker nodulization

There is a good summary on the influence of liquid phase on nodulization here: http://cementamericas.com/mag/cemen...

Re: Reduction in clinker production

2% CO at kiln inlet should be unacceptable. You should try increasing the draft to increase the oxygen at kiln inle...

Re: Burner Positions

The optimum position depends on many factors. In the past, it was common practice to point the burner a little bit ...

Re: Effect in Preheater exit temp.

I concur with the last statement of Mr. Hussaini comment. This is not the ash content that has relevant effect on th...

Re: Mass Balance

Ted Krapkat: This combined stream is what is fed to the preheater,   This is exactly what I meant. As it ...