Ted Krapkat

Posts

re Copper (Cu) impact on clinker or cement quality?

Hello Viswam, It depends on the composition of the copper slag. Slags from different suppliers have different a...

re stage 3 cyclone coating

Hello Fjalali, In a way, yes.  As I said earlier, due to the high chloride content of your bypass dust, your by...

re Copper (Cu) impact on clinker or cement quality?

Hello Raju, Copper can have both beneficial and detrimental effects on clinker quality. Up to about 1% coppe...

re High MgO in limestone

Hello Haliff, Above 2% in the clinker, MgO will appear as the mineral periclase. If the particle size of this p...

re stage 3 cyclone coating

Hello, Thank you for your analyses. Both the hot meal and bypass dust have a very low molar Alk/SO3 ratio. (...

re Product facing 28 strength lower problem

Hello Raju, I have heard of quicklime being used in Autoclaved Aerated Concrete (AAC) to produce bubbles of hyd...

re stage 3 cyclone coating

Hello, Based on the analysis you've given, the sample probably contains mostly gypsum and possibly some sulphos...

re Impact of ALKALY, SULPHURE and CHLORINE in Kiln operation and clinker quality ?

Hello Haliff, Yes, you are correct. The S/A ratio uses the same calculation method, it is simply the inverse of...

re Product facing 28 strength lower problem

Hello Raju This is a common challenge nowadays. With the constant economic pressure to increase mineral additio...

re Bond index and energy index?

Hello Raju, Not exactly... I'm not an expert on this, but as I understand it... the constant C can only be o...