jatin
7 posts
TimePosted 30/10/2007 07:37:45
jatin says

Cement mill Residue

Sir,

We have a ball mill for cement grinding. The residue on 45 mic is 15 to 16 % for blains value of 3400 cm²/grms, any idea how to reduce the residue to around 10 %.

jatinder...

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

R.M.SAHU
4 posts
TimePosted 02/11/2007 09:39:13
R.M.SAHU says

Re: Cement mill Residue

Dear Mr Jatin,

You have not mentioned circuit of your mill.I assume that it might be a closed circuit cement mill. Best possible way to reduce residue on 45micron is by increasing circulation factor across the mill.The other way is to decrese cut size of your dynamic separator by increasing cage rotor speed.

 

R.M.SAHU,

INDIA

Reply

branco
9 posts
TimePosted 07/11/2007 00:49:54
branco says

Re: Cement mill Residue

Hi Jatinder,

You could increase the speed of your separator rotor, i.e. increase recirculation load. But you may then experience an excessively high blaine value. The best way to make a balance on mesh passing and blaine is to play around with feed tonnage and separator rotor speed.

 Branco

Reply

Saddam Hu
28 posts
TimePosted 18/01/2008 21:25:14
Saddam Hu says

Re: Cement mill Residue

Decrease production rate ;)

Reply