My cement mill plant is equipped with a 250m type fk pump with an arzen compressor(delta blower) expected to transport cement to the silos.usually the compressor either trips on high discharge temperature or the fk pump trips on high current.can anybody tell me what the problem might be?personally i feel there is a need for one to know the quantity of air required to transport a particular quantity of cement thru a particular distance and also the size of the pipe required.All these information is missing.Can anybody help with these information?my email is adeboye.owoyemi@gmail.com
boye
cement transport problem
Vikpro
Dear Boye,
I need few information to check & design your Pnumatic conveyor.
| Plant elevation ( Msl ) | Mts | |
| Maximum Ambient temp. | °C | |
| Blower out Temp. | °C | |
| Material Bulk Density | Kg/M3 | |
| Material Capacity | Kg/ Hr | |
| Length of pipe | mts | |
| Pipe Inlet | Round or Square | |
| Type of Pipe bends | R/D | |
| Nos of bends | ||
| Type of Tees | Angle ° | |
| Nos of tees | ||
| Widening of Cross section | Angle ° | |
| Discharge opening | Deflactor, pipe, cowl | |
| Type of pipe | Cast Iron etc |
Vikpro
boye
see the required info;
i cant really undrerstand what u mean by plant elevation.d value i provide supplied here is for the silo outlet elevation to d fk pump discharge outlet.and type of bend is equally not clear.but i have 13 bends 8 90 deg,4 60deg bends.also the pipe is of uniform cross section 10 inch pipe..let me know if u need furhther info.tnx in advance
| Plant elevation ( Msl) | 38m | Mts |
| Maximum Ambient temp. | 32 | °C |
| Blower out Temp. | 200 | °C |
| Material Bulk Density | 1.5 | Kg/M3 |
| Material Capacity | 100000 | Kg/ Hr |
| Length of pipe | 107 | mts |
| Pipe Inlet | round | Round or Square |
| Type of Pipe bends | R/D | |
| Nos of bends | 13 | |
| Type of Tees | 60 | Angle ° |
| Nos of tees | 2 | |
| Widening of Cross section | Angle ° | |
| Discharge opening | pipe | Deflactor, pipe, cowl |
| Type of pipe | mild steel | Cast Iron etc |
boye
see the required info;
i cant really undrerstand what u mean by plant elevation.d value i provide supplied here is for the silo outlet elevation to d fk pump discharge outlet.and type of bend is equally not clear.but i have 13 bends 8 90 deg,4 60deg bends.also the pipe is of uniform cross section 10 inch pipe..let me know if u need further info.tnx in advance
| Plant elevation ( Msl) | 38m | Mts |
| Maximum Ambient temp. | 32 | °C |
| Blower out Temp. | 200 | °C |
| Material Bulk Density | 1.5 | Kg/M3 |
| Material Capacity | 100000 | Kg/ Hr |
| Length of pipe | 107 | mts |
| Pipe Inlet | round | Round or Square |
| Type of Pipe bends | R/D | |
| Nos of bends | 13 | |
| Type of Tees | 60 | Angle ° |
| Nos of tees | 2 | |
| Widening of Cross section | Angle ° | |
| Discharge opening | pipe | Deflactor, pipe, cowl |
| Type of pipe | mild steel | Cast Iron etc |