Kumar
Registered User
New Delhi
Employee
Dear Sir, is in your cement plant any gas analyser at kiln inlet working properly? in our plant we ar...
Dear Sir, I will feel highly obliged if you send me the copy on the topic of discussion at my mail id vipanku...
Dear sirs, I would like to know about the factors which decides about the kiln direction of rotation...
Thanks Sir.
Dear Sir, Can someone share the heat up curves of kiln for 8,12,16,24,36,48 and 72 hrs? Regards
Thank Sir, Our kiln is supplied by IHI and fitted with flash furnace in the kiln riser and...
Dear Sir, Thanks for your reply. I think inserting the tyre from the kiln inlet will give indication of high inlet...
Dear Sir, Kindly share your opinion or experience about the preffered location for inserting the whole or half ...
Thanks Mr Arvind.
Dear Sir, We are noticing higher kiln creep at our middle tyre(>60mm) and at the 3rd tyre inlet side (>30mm). W...
;