vinayak
Registered User
Hi As you know, it is very difficult to explain the heat balance in this forum and it needs atleast 3 hours to dis...
Hi Coating at kiln inlet ia mainly due to the volatiles like Chlorides, alkalies ( Na2O and K2O) and SO3. To minimi...
Hi You can refer the training coarse material given by FLS or Wholcim.Onceyou made the format ready in excel sheet ...
Hi Normal life of hood arches is about 2 to 3 years. I don't expect a design problem.It is very difficult to come t...
Hi If that is the case the following may be tried 1. By increasing the rawmeal fineness 2. By increasing the calc...
hi If it does not happen we can diagonise( just kidding). When you reduce the liter weight you would have reduced ...
Hi friends I hope that both of you are correct. But only the conditions are different. For the same flow, as in t...
Hi Apart from the kiln load factors, normally near the second tyre a mnahole provided to remove the used bricks and...
Hi You may multiply the fuel feed by CV For ex Kiln fuel feed rate = 6000 kgs/hr C.V = 6500 ...
;