admin
Posts: 1156
Strapline: Registered User
Location:
Occupation:
Posts
Kiln start-up and shut-down Question 1
In our SLC kiln, we frequently found melting material during kiln start up. What are the possible causes such as insu...
Re: Kiln start-up and shut-down
It is very difficult to say what material is melting without seeing the situation on the ground. However you must rem...
Kilns Question 1
What is the emissivity of a kiln's shell? I ask this because i need to know it to take infrared thermography of the s...
Re: Kilns
The emissivity of the rough oxidised kiln shell at 400 degrees C is approximately 0.9. According to my notes emissivi...
Kilns Question 2
If you have any knowledge about clinker kilns of 1000 to 1400tpd capacity being in operation today and being part of...
Re: Kilns
There are certainly precalciner kilns of 1000 to 1400tpd capacity in operation today. Arguably this is well below the...
Kilns Question 3
We frequently face with ball formation problem in the kiln for two months. We are studying the case and investigating...
Re: Kilns
There are two potential causes that I would investigate: 1. a change or variability in the MgO content of your ki...
Kilns Question 4
Does better nodulisation mean more consistent size of nodules with less dust or with less large nodules ? What might ...
Re: Kilns
Your chemistry does not sound abnormal and we have discussed the possibility that the large nodules are caused by MgO...