wilfredzieri

wilfredzieri
Threads Started: 1
Posts: 14
Strapline: Registered User
Location:
Occupation:

Posts

Wet kiln HCL and SO2 emission absorption

Are there any experience reports for the rate of absorption (HCL, SO2) of a wet kiln system? In additional - ro...

Re: P.C Coating

Although it is always wise to get a chemical analysis of the coating I assume it is mainly sulfates and chlorides. ...

Re: m3/hr to Nm3/hr.

Vact = Vnorm * (1013/p act)*((T+273)/273) Vact = actual gas volume [m³/s] Vnorm = gas volum at norm conditions [Nm...

Re: about RSP calciner

The RSP calciner is characterized by a combustion chamber (top - down gas flow) which is connected to the calciner j...

Re: kiln feed SO3

the max. SO3 level has to be seen with several other indicators preheater kiln: alkali/sulfur ratio = 0,5 ; max. %...

Re: Raw mill drying problem

Depending on your preheater arrangement there may be the possibility to operate a 5-stage preheater during the dry s...

Re: Using industrial waste for cement burning

Just a few of those many subjects to consider when not properly applied are a. increased specific gas volume (appro...

Re: Coating formation in Kiln Inlet

It can be very misleading to give advice without knowing all the operating data and details over a longer period. H...

Re: 2nd stage showing dead cold on infrared image

Firstly could you please inform what temperature is indicated by "blue" on the thermal image. Secondly it would be ...

Re: CALCINER

Dear Rathul; to calculate the stochiometric quantity I will post you the formular which I use for quick evaluation ...