Ted Krapkat

Posts

re boulder in kiln

Hello Siddhant, It is likely that these balls are caused by too much liquid phase. Your Silica Ratio (SR) is qu...

re boulder in kiln

Hello Yndiaye, Have you broken open the clinker boulder to see if the centre of the ball is hard burnt or under...

re Pozzolan addition directly into Cement Mill

Hello Shastri, How hard is the pozzolan you are using?  What is the top size of the pre-ground material from...

re Traditional Analysis by Gravimteric & Volumetric Analysis of Cement or Clinker for Determination of SiO2,Al2O3 ,Fe2O3 & Cao & MgO

Hello Ravi, I have researched and found enough information to attempt an more detailed explanation on your ques...

re Traditional Analysis by Gravimteric & Volumetric Analysis of Cement or Clinker for Determination of SiO2,Al2O3 ,Fe2O3 & Cao & MgO

Hello Ravi, To answer your questions;- 1. Dear Sir We adopting the Method for Determination of SiO2 as foll...

re Clinker grindability

Hello Shastrib, The Bond Work Index is one practical method.   Regards, Ted.

re low sr slurry

Hello Stephen, What is the SR of your clinker? Since clinker SR is inversely related to quantity of liquid p...

re vibration vertical roller mill

Hello Ashkan, The most important factor which determines the level of vibration in a VRM is the thickness and c...

re form of silica for alite and belite formation

Hello Stephen, Amorphous silica is far more reactive than quartz and is the preferred type of silica for good k...

re Effect of Basalt in kiln feed

Hello Abuthalib, Basalt is very hard and contains high concentrations of alkalis (2-6%) and MgO (5-12%) so you ...