Ted Krapkat
Registered User
Gladstone, Queensland, Australia.
Plant Chemist, Cement Australia.
Hello Ahmed, The percentage of alkalis, chloride and sulphur in kiln bypass dust should be high for good bypass...
Hello BR, Have a look at the discussions in the links below and see if they give you the information you requir...
Hello Rajuram, Water soluble sulphates can be extracted from finely ground clinker using hot water, followed by...
Hello Dogra, It will depend on your SO3/Alkali molar ratio. If this ratio is less than or equal to 1, then all ...
Hello Raju, Since both are a measure of particle size, residue is normally linked to Blaine. But not always. ...
Hello Raju, To answer your questions;- 1. Yes, it's true that the first oxidised form of sulphur in the kiln...
Hello XXX, At 0.8% SO3 in the clinker your sulphur input does not appear to be exceptionally high. (unless you ...
Hello Cement Man, A last resort method of increasing your kiln inlet O2 is to inject oxygen. A possible drawbac...
Hello Dharmesh, I agree with 123red. The number, distribution and size of belite (C2S) clusters have a signifi...
Hello Siddhant, Adding flyash containing high CaO as an alternative raw material can have the following benefit...
;