gks

Posts

re coal ash effect on kiln operation.

Dear all, How to control fuel ratio in PC ( 5.0 % coal & 95.0 % gas than 8.0 % & 92 %).  1. PC temp control ...

re High chloride in hot meal

Dear Team, After your AFR  action . Kiln operation  will improve . But if having margin your  Ph fan. first imp...

Roll press vibration

Dear expert,   What are  the control factor for rollpress vibration . Vibration controll by feed stock moisture...

Gypsum formation lime stone

Dear expert, What problem will come if 100%Gypsum  is replaced  by lime stone make gypsum by sulphoric acid (98...

re TSR % in kiln from 4.5 % to 10.%

 TSR  formula-- Total heat of any fuel  replaced by AFR is given    %TSR . Total heat required in kiln -- Z ...

re Low LSF of the Kiln return dust

Low LSF in Kiln return dust due to following  reason. 1.high reduced of  Raw meal . Check 45 micron residue ...

re pond fly ash

Dear expert ,    Pl give concept for selection grinding system  for pond fly ash grinding  upto 100 tph capa...

re Purity of gypsum

Dear all,        High purity gypsum required % reduced , So current trend to use 90 % purity gypsum.   (  45...

SLAG GRINDING

Dear expert,             Give best slag grinding equipment selection for cost optimization. As SLAG having high...

re High CO up to 2% at kiln inlet

Dear,           1.   Unburn coal is going from flame by long propagation . Increase PA pressure  upto 1600 mmwg...